Logo



GN30 Reddy Heaters Blueflame ventfree garage heaters

Common GN30A Ready Heater Parts:





110186-01 098514-01 120790-01 thermocouple for ODS pilot GN30A Reddy heater parts




GN30A Reddy Heaters Blueflame ventfree Heaters for garages



  • Wall Mount Heater
  • GN30A - Natural Gas Reddy Heater
  • Manual Control Operation
  • Save on heating costs. The 99% heating efficient designs require no outside venting, so all the heat stays in the room.
  • The GN30A Provides easy, economical installation, with no vent or chimney required, and a built in pressure regulator, this heaters installation is an easy job*. (*Professional installation recommended)
  • Safe and clean burning, Reddy Heaters ventfree garage heaters are design certified by the American Gas Association and meet or exceed all government safety performance standards.
  • A dual purpose safety pilot system protects against oxygen depletion and any interruption in the fuel supply. If either occurs, the gas is shut off to the burner, turning the heater off.
  • Provides heat during power outages. No electricity required, making them ideal as back up emergency heat.
  • Clean, quiet, odorless operation
  • Reddy Heaters GN30A has easy to use top mounted controls
  • push button ignition. No matches required.
  • Sheet metal panel & safety grill (this unit does not have glass)
  • Low heat 15,000 BTU's
  • High heat 30,000 BTU's
  • GN30A Heater Dimensions 24.5" H x 25.5" W x 8" D


  • More Reddy heaters






Important Heater Information



  • Heater Installation must be done by qualified service persons.
  • Read Owner's Manual before using.
  • Check local codes and ordinances for permitted vent free heater uses.
  • Not for use in recreational vehicles.
  • All heater products approved for manufactured (mobile) home installation.
  • We reserve the right to amend heater specifications without notice.
  • Use with adequate air (ventilation) only. vent free heaters humidify while they heat.
  • Vent free provides water vapor in the area heated. Refer to owner's manual for specifics.
  • Heating areas based on rooms with 8' ceilings.
  • Operating heaters at elevations above 4,500 ft. could cause nuisance outages.
  • Other propane/LP gas Reddy Heaters:
    GN30TA
  • Operating GN30A heaters at elevations above 4,500 ft. could cause nuisance outages. REASON: thinner air at higher elevations causes the ODS pilot to shut the heater off. This is accomplished as the pilot flame lifts off of the thermocouple ceasing the signal sent to the gas valve.
  • Vent free heater can not be converted between fuel types.
  • ANSI Z21 11.2 Standard and National Fuel Gas Code revised in 1994 to permit wall mounted installations of 10,000 btu vent free heaters in bedrooms and 6,000 Btu in Bathrooms.
    Always check local codes before installing



Heater Parts

Heater Manuals

Home

© 2004-2021 New Beginnings Management Company, Inc.