Common GWRN30A GlowWarm Parts:

• 098271-09 Ignitor Cable
• 110803-03 * ODS / Pilot Assembly (Includes 110186-01 Thermocouple)
• 110186-01 Thermocouple with Clip (2 Wire Thermocouple) (See Fig 2)
• 099415-19 Pressure Regulator
• 097159-04 Piezo Ignitor
• PP100A Blower Fan Kit

* If replacing ODS pilot and your model is Pre 2002, your part number
will be 100701-03 for natural gas models.
The thermocouple part number will be 098514-01 (See Fig 3). The electrode
part number will be 098594-01.

Click Here for Owners Manual

	GWRN30A GlowWarm Plaque Infrared Heaters
	Click Here for GlowWarm heater Models GWRN30A - Natural Gas Heaters Wall Mounted Heater (optional floor kit sold seperately)) Manual Control Operation Save on heating costs. The 99% heating efficient designs require no outside venting, so all the heat stays in the room. The GWRN30A heaters provide easy, economical installation, with no vent or chimney required, and a built in pressure regulator, installation is an easy job*. (*Professional installation recommended) Safe and clean burning, GlowWarm ventfree gas heaters are design certified by the American Gas Association and meet or exceed all government safety performance standards. A dual purpose safety pilot system protects against oxygen depletion and any interruption in the fuel supply. If either occurs, the gas is shut off to the burner, turning the heater off. Provides heat during power outages. No electricity required, making them ideal as back up emergency heat. Clean, quiet, odorless operation GlowWarm GWRN30A heaters have easy to use top mounted controls Push button ignition. No matches required. Decorative safety grille Low heat 6,600 BTU's (Natural Gas model) Medium heat 18,000 BTU's (Natural Gas model) High heat 30,000 BTU's (Natural Gas model) GWRN30A Heater Dimensions 24.5" H x 25.5" W x 8" D

	Important Heater Information
	Heater Installation must be done by qualified service persons. Read Owner's Manual before using. Check local codes and ordinances for permitted ventfree heater uses. Not for use in recreational vehicles. All heater products approved for manufactured (mobile) home installation. We reserve the right to amend heater specifications without notice. Use with adequate air (ventilation) only. ventfree heaters humidify while they heat. Ventfree provides water vapor in the area heated. Refer to owner's manual for specifics. Heating areas based on rooms with 8' ceilings. Other natural gas GlowWarm Heaters: GWRN10 GWRN18A GWRN18TA GWRN30TA Operating GWRN30A heaters at elevations above 4,500 ft. could cause nuisance outages. REASON: thinner air at higher elevations causes the 110803-03 and 100701-03 ODS pilot to shut the heater off. This is accomplished as the pilot flame lifts off of the 110186-01 and 098514-01 thermocouple ceasing the signal sent to the gas valve. Ventfree heater cannot be converted between fuel types. ANSI Z21 11.2 Standard and National Fuel Gas Code revised in 1994 to permit wall mounted installations of 10,000 btu ventfree heaters ( GWRN10 in bedrooms. Always check local codes before installing