GWN10 Glo Warm Blue Flame ventfree heaters

Common GWN10 Heater Parts:

120790-01 110186-01 098514-01 thermocouples and ODS pilots GWN10 glo warm heater parts and heaters

GWN10 Glo Warm Natural gas ventfree Blue Flame heater,
with manual control and 10,000 btu’s

The GWN10 Blue Flame heater works much like a central heating system,
the room is wrapped in a blanket of comfort as the air is warmed.

A Glo Warm Blue Flame heater does not require electricity to run,
enabling you to weather the cold with power or without.

Glo Warm Blue Flame Heaters GWN10

  • GWN10 - Natural Gas heaters
  • Manual Control Operation
  • Wall Mount heater
  • Save on heating costs. The 99% heating efficient designs require no outside venting, so all the heat stays in the room.
  • The ventfree blue flame heater provides easy, economical installation, with no vent or chimney required, installation is an easy job*.
  • *Professional installation recommended
  • Safe and clean burning, Glo Warm ventfree heaters are design certified by the American Gas Association and meet or exceed all government safety performance standards.
  • A dual purpose safety ODS pilot system protects against oxygen depletion, when the pilot flame is lifted from the thermocouple the gas is shut off to the burner by the ODS pilot causing the heater to turn off.
  • Provides heat during power outages. No electricity required, making these ventfree blue flame heaters ideal for back up emergency heat.
  • Clean, quiet, odorless operation
  • Easy to use  top mounted controls
  • Piezo ignitor push button ignition. No matches required.
  • Decorative safety grill and tinted glass
  • Low heat 5,000 BTU's
  • High heat 10,000 BTU's
  • GWN10 Heater Dimensions 21.5" H x 13.5" W x 7" D

  • More GloWarm heaters

Important Heater Information

  • Heater Installation must be done by qualified service persons.
  • Read Owner's Manual before using.
  • Check local codes and ordinances for permitted ventfree heater uses.
  • Not for use in recreational vehicles.
  • All heater products approved for manufactured (mobile) home installation.
  • We reserve the right to amend heater specifications without notice.
  • Use with adequate air (ventilation) only. ventfree heaters humidify while they heat.
  • Ventfree provides water vapor in the area heated. Refer to owner's manual for specifics.
  • Heating areas based on rooms with 8' ceilings.
  • Other natural gas Glo Warm Heaters:
  • Operating GWN10 heaters at elevations above 4,500 ft. could cause nuisance outages.
    REASON: thinner air at higher elevations causes the ODS pilot to shut the heater off. This is accomplished as the pilot flame lifts off of the thermocouple ceasing the signal sent to the gas valve.
  • Ventfree heater cannot be converted between fuel types.
  • ANSI Z21 11.2 Standard and National Fuel Gas Code revised in 1994 to permit wall mounted installations of 10,000 btu ventfree heaters ( GWN10T GWN10 GWP10T GWP10 ) in bedrooms and 6,000 btu heaters ( GWN6 GWP6 ) in bathrooms.
    Always check local codes before installing

Heater Parts



© 2004-2020 New Beginnings Management Company, Inc.