 |
Common GWN6 Heater Parts:
GWN6 GloWarm Natural gas ventfree BlueFlame heater,
with manual control and 6,000 btu’s
The GWN6 BlueFlame
heater works much like a central heating system,
the room is wrapped in a blanket of comfort as the air is warmed.
A GloWarm BlueFlame heater does not require electricity to run,
enabling you to weather the cold with power or without.
|
|
GloWarm Blueflame Heater GWN6
|
|
|
|
|
-
GWN6 - Natural Gas heaters
-
Manual Control Operation
-
Wall Mount heater
-
Save on heating costs. The 99% heating efficient designs require no outside
venting, so all the heat stays in the room.
-
Blueflame ventfree heaters provide easy, economical installation, with no vent or chimney required,
installation is an easy job*.
- *Professional
installation recommended
-
Safe and clean burning, GloWarm ventfree heaters are design certified
by the American Gas Association and meet or exceed all government safety
performance standards.
-
A dual purpose safety ODS pilot system protects against oxygen depletion, when the pilot flame is lifted from the thermocouple the gas is shut off to the burner by the ODS pilot causing the heater to turn off.
-
Provides heat during power outages. No electricity required, making these ventfree heaters
ideal as back up emergency heat.
-
Clean, quiet, odorless operation
-
Easy to use top mounted controls
-
Piezo igniter push button ignition. No matches required.
-
Decorative safety grill and tinted glass
-
Low heat 4,400 BTU's
-
High heat 6,000 BTU's
- GWN6 Heater Dimensions 21.5" H x 13.5" W x 7" D
- More GloWarm heaters
|
|
|
|
|
Important Heater Information |
|
|
|
|
- Heater Installation must be done by
qualified
service persons.
- Read Owner's Manual before using.
- Check
local codes and ordinances for permitted ventfree heater uses.
- Not for use in recreational
vehicles.
- All heater products approved for
manufactured
(mobile) home installation.
- We reserve the right to amend
heater
specifications without
notice.
- Use with adequate air (ventilation)
only. ventfree heaters humidify while
they heat.
- Ventfree provides water vapor in the area
heated. Refer to owner's
manual for specifics.
- Heating areas based on rooms with
8'
ceilings.
- Other natural gas Glo Warm Heaters:
GWN10 GWN10T GWN20TA GWN30TA
|
- Operating GWN6 heaters at elevations
above 4,500 ft. could cause nuisance outages.
REASON: thinner air at higher elevations causes the ODS pilot to shut the heater off. This is accomplished as the pilot flame lifts off of the thermocouple ceasing the signal sent to the gas valve. - Ventfree heater cannot be converted between
fuel types.
- ANSI Z21 11.2 Standard and National
Fuel Gas Code revised
in 1994 to permit wall mounted installations of 10,000 btu ventfree heaters ( GWN10T GWN10 GWP10T GWP10 ) in bedrooms and 6,000 btu heaters ( GWN6 GWP6 ) in bathrooms.
Always
check local codes before installing
|
|
|
|
|
